Getting started

All it really takes is a socket to unbolt the grill, a few screwdrivers, pliers for shaping the gutter mesh, and most importantly a Dremel tool. Start by remove the grill and unbolt the upper and lower black braces and the center support rod. Find a comfortable place to work and put a cutting wheel on the Dremel. The first cuts are rough to remove the bars above and below the bowtie. Don't worry about how these cuts look, they will be cleaned up later. Just use two hands on the Dremel so you don't cut anything that's going to stay. You may flip the grill over and make some cuts from the back if needed. Heres what the rough cuts look like.

This information is used with permission. It's original content resides at ChevyHHRFamily